Version: 010622
SUPERSLIDE INSTRUCTION MANUAL Page 17 of 19
SAVE PERSONALITY
Saves the current configuration in a personality register. Tap numeric keypad keys after selecting this item
to show the names of the various registers. Tap ENTER when an unused register is seen (indicated by the
name DEF for default). You may enter any 16 character name you wish by using the KNOB to select a letter
or number, and the RIGHT and LEFT arrow keys to move to other character positions (the name defaults to
"REG X"). Tap ENTER when done.
RECALL PERSONALITY REGISTER
Recalls a previously stored personality register. The last saved or recalled personality register number is
shown along with it’s name. Tap numbers on the numeric keypad to show the names of the other registers.
Tap ENTER to recall one, or HOME key to cancel.
RECALL DEFAULTS
Restores the factory default configuration. Tap ENTER to recall defaults, any unsaved configuration settings
will be lost. Saved personality registers remain unaffected. Tap HOME to cancel.
CALCULATOR STYLE # KEYS
Changes the numeric keypad to calculator style (7-8-9 on the top row, 1-2-3 on the bottom). The default is
telephone style with 1-2-3 on top and 7-8-9 on bottom. It is necessary physically to remove these keycaps
and swap their positions when changing this menu item. The keypad style is stored separately in protected
memory and is never erased or changed except by using this menu item.
OPER PREFS
A submenu containing these operational preference items:
ADJUST SLIDE
DÉTENTED SLO-MO
QTY OF DÉTENTES
MAX FWD SPEED
MAX REV SPEED
ADJUST SLIDE
Allows the operator to adjust the location of The Slide’s play, still, and reverse play breakpoints and its
détente speeds. When The Slide is at a breakpoint and this menu item is selected, holding ENTER while
moving The Slide changes the position of the breakpoint. The Slide moves freely within the breakpoint’s
allowable range and mechanical resistance is felt when trying to move outside this range to an illegal
position. The quantity of détentes affects the minimum distance that can be set between the play and still
breakpoints even if détented mode is disabled. If the play breakpoint is moved to its upper limit, playback
speed cannot exceed 100% (play speed). If the reverse play breakpoint is set to its lower limit, reverse
playback cannot exceed -100%.
When in détented mode, in this menu item, and at a détente point, holding ENTER while turning the KNOB
adjusts the speed assigned to the détente. A détente speed can be adjusted only between the next lower
and the next higher détente or breakpoint speed.
DÉTENTED SLO-MO
Enables/disables the détented mode. While disabled (the default), The Slide moves freely between the zero
and 100% speed breakpoints and speed is varied in one percent increments. While enabled, mechanical
détentes are felt between these points and speed changes step between discrete speeds that are assigned
to the détentes. These are the slow motion speeds that exhibit the least judder (motion distortion). If
détented mode is enabled, a double-tap of the SLOW key temporarily disables the détented mode until
SLOW, STOP, or PLAY is single tapped. If SLOW is single-tapped, and the speed stored with the clip is not
a détente speed, the non-détented mode is used as if SLOW was double-tapped.
