ITEM # EPW1300 Electric Pressure Washer Assembly & Operating Instructions
7
CLEAN UP
• Turn the Power Switch to the OFF position.
• Turn the water supply off.
• Point the gun in a safe direction and release water, before disconnecting high-pressure hose connection.
• Disconnect high-pressure hose from the pressure cleaner and gun.
• Disconnect garden hose from the pressure cleaner.
• Remove quick coupler fitting from garden hose and attach to the nipple portion of the fitting installed on the pressure
cleaner for storage.
• Tip the unit to drain any remaining water from inlet and outlet fitting.
• Remove the water intake filter then rinse it with water to remove dirt.
• Drain detergent reservoir and flush with running water.
• Clean and dry any remaining water left on the machine.
• Store the pressure washer, parts, and accessories in an area with a temperature above 32° F.
LONG TERM STORAGE
Follow the above clean-up procedures, perform the following steps:
• After disconnecting the water supply, and before disconnecting the high-pressure hose, turn the pressure cleaner on
for 2-3 seconds. This allows any remaining water in the pump to be released.
TURN UNIT OFF IMMEDIATELY. CONTINUED USE OF THE PRESSURE CLEANER WITHOUT WATER SUPPLY
ATTACHED WILL CAUSE SEVERE DAMAGE TO THE UNIT
• Store the pressure washer, parts, and accessories in an area with a temperature above 32° F.
MAINTENANCE
WARNING: DAMAGE TO THE PUMP ASSEMBLY WILL OCCUR IF YOU FAIL TO COMPLY WITH THE STORAGE
INSTRUCTIONS.
• DO NOT add oil, as the pressure washer is supplied with a closed lubrication system.
• Before every use, check all hoses and accessories for damage.
• Check the inlet filter for deposits. Clean the filter regularly.
