ASSEMBLY
Unplug the power plug from the AC power source before assembly, adjustments, or adding/removing accessories.
Unpack product from package and review contents. Keep all packaging until product has been reviewed.
Be prepared and braced for the twisting action of the polisher. Never put the Polisher down until the Rotating Wheel has come
to a complete stop. The Rotating Wheel can grab the surface and pull the tool out of your control.
Wear safety eyewear and dust filters or respirators while using the tool.
The motor may overheat if run for long periods of time. If the motor begins to show signs of overheating, turn the Polisher “Off” and
allow the motor to cool before continuing.
When waxing or polishing your car/truck, do not run the vehicle in an enclosed area. Carbon monoxide is a colorless, odorless, vapor
emitted from a vehicle’s running engine that may cause severe injury or death if inhaled.
Make sure the car/truck being waxed/polished is clear of foreign matter that could damage the tool.
1. Unplug the power cord from the electrical outlet before making any adjustments to the tool.
2. Always use a clean terry cloth Bonnet. Place it securely onto the Wheel Pad.
3. Before use, make sure the car/truck has been thoroughly cleaned and is free of dust, dirt, oil, grease, etc.
4. Use approximately two tablespoons of wax (not included) on the Waxing Bonnet. Do not put wax directly on the surface of the
car/truck. You may choose to add additional wax, depending on the size of the car/truck.
5. Plug the Power Cord into an extension cord (not included). Plug the extension cord into a grounded 120V outlet.
6. Keep the extension cord out of the way while using the Polisher.
7. Start and stop the Polisher while it is held firmly against the surface of the car/truck. Otherwise the Waxing Bonnet may be thrown from the
Pad.
8. Hold the Polisher firmly with both hands. Turn the Power Switch (On/Off) to the “ON” position and allow the Pad to rotate to its full speed.
9. Apply wax to the vehicle, using broad strokes in a criss-cross pattern. Apply the wax evenly. Add additional wax as needed.
10. When the wax has been applied to the car/truck, turn the Power Switch (On/Off) to the “OFF” position. Unplug the Power Cord from the
electrical extension cord, and unplug the extension cord from the 120V electrical outlet.
11. Remove the Bonnet from the Pad. With the Waxing Bonnet in your hand apply the wax to the remaining Hard-to-Reach areas of the vehicle
such as around lights, door handles, under bumpers, etc.
12. Allow time for the wax to dry on the vehicle.
13. Place a clean Polishing Bonnet securely onto the Pad.
14. Plug the Power Cord of the into the electrical extension cord. Plug the extension cord into 120V electrical outlet.
15. Place the extension cord over your shoulder to keep the cord out of the way.
PS07225 10 Inch Car Polisher Assembly & Operating Instructions
6
