CPsingle, CPdouble
– Inspections prior to initial operation and routine inspections according to the Ordinance on Industrial Safety and Health (Be-
trSichV) are performed,
– The respective national accident prevention regulations are observed,
– The permissible data and operational conditions are maintained,
– Safety guards are used and mandatory maintenance is performed,
– Legal regulations are observed during disposal.
Maintenance, Repair
Please note during maintenance and repairs:
– Repairs to the unit must be performed by Bühler authorised personnel.
– Only perform conversion-, maintenance or installation work described in these operating and installation instructions.
– Always use genuine spare parts.
Always observe the applicable safety and operating regulations in the respective country of use when performing any type of
maintenance.
DANGER
Electrical voltage
Electrocution hazard.
a) Disconnect the device from power supply.
b) Make sure that the equipment cannot be reconnected to mains unintentionally.
c) The device must be opened by trained staff only.
d) Regard correct mains voltage.
DANGER
Toxic, corrosive condensate
a) Protect yourself from toxic, corrosive condensate when performing any type of work.
b) Wear appropriate protective equipment.
c) Please note the national safety rules!
DANGER
Use in explosive areas
The equipment is
not
suitable for use in explosive areas.
5
Bühler Technologies GmbH
BE450021 ◦ 01/2017
