CU-EMA+
6.1 Maintenance Intervals
The frequency of inspections depends on the operating conditions and may need to be adjusted by the operator.
We recommend at a minimum observing the following maintenance and inspection intervals:
Maintenance interval and items
Entire device:
6 months
Functional test
Entire device:
3 months and before restarting
Test tightness
Entire device:
weekly and before restarting
Visual inspection: Check for leaks and corrosion, check seals, replace parts if damaged or
worn
Peristaltic pump:
3 months and before restarting
Pump maintenance, e.g. checking hoses or replace wear items
Moisture detector:
3 months and before restarting
Cleaning and calibrating the moisture detector
Periodic inspections
See national regulations
Devices must be inspected regularly to maintain their proper condition. Please observe the national regulations.
All maintenance work is detailed in the respective manual for the component.
Damaged warning signs must be replaced.
Occasionally verify the operation instructions, drawings and operation instructions are complete. These must be in good condi-
tion. If necessary, replace with new copies.
6.2 Cleaning
NOTICE
Please note:
Always clean the system dry.
Also observe the instructions for individual components in the event of exceptions.
Particularly observe the warnings in chapter Maintenance.
21
Bühler Technologies GmbH
BE440029 ◦ 10/2020
