bühler
Allied Front-End Loader
- 23 -
P4094
MAINTENANCE
General Inspection:
CAUTION
Lower attachment and loader to ground, place all
controls in neutral, stop engine, set parking brake and remove ignition key before
inspecting, servicing, adjusting or repairing loader.
WARNING
Relieve hydraulic pressure before repairing, adjusting
or disconnecting hydraulics components. Escaping hydraulic oil can penetrate
skin causing serious personal injury. If injured consult a physician immediately.
WARNING
Never work beneath a raised loader unless it is
securely supported. The control lever can be moved or a hydraulic leak could
cause the loader to drop resulting in serious injury or death. Refer to the
Lift
Lock Instructions Decal
for proper use of the lift locks.
Lift Locks:
The lift locks on your loader are to be used whenever someone is
attempting to be under the loader or for tractor servicing. When using the locks
ensure loader is free of any load in the loader attachment or no attachment.
To engage, raise loader sufficient for lift lock
clearance. Swing each lift lock forward
resting on the cylinder rod below the head
plate as shown. Turn off the tractor and
slowly lower the loader until the cylinder head
plate rests up against the lift lock. Then lock
joystick in neutral position.
Pins and Bushings:
Every 6 months or 1000 hours check loader and cylinder
pivots for movement that would be due to bushing or pin wear. Change bushings
when excessive movement is noticed and replace any worn or rough surfaced
pins.
Summary of Contents for 2595
