10
3
Operation
Please always pay attention to the safety information in chapter 2.
Attention!
Observe the following instructions to prevent the risk of injuries and
damage to the device:
Never lay down the device on its side in its hot operative state. This
could cause the unchecked leakage of adhesive. Danger of burns!
Never remove the adhesive residues from the melting chamber by
force (e.g. with a scraper or screwdriver). This could damage the inte-
rior lining of the melting chamber.
Never loosen „frozen“ hot-melt adhesive candles by force (e.g. with
tongs).
1.
2.
3.
3.1
Initial operation
Insert the mains plug into a power socket with protective earth.
Switch the device on using the on/off switch (5).
The red operating lamp on the on/off switch (5) illuminates. The device
starts to warm up immediately.
If the adhesive candle has already been inserted, liquid adhesive can
come out of the nozzle. You should place the device on a suitable surface
to protect against this. Allow the device to heat up for between 3 and 4
minutes (depending on adhesive type).
Push the hot-melt adhesive candle to the opening in the rear of the
device as far as the black insulation socket (8)
3.2
Setting the temperature
Use the included screwdriver (9) to set the temperature to the desired value
at the adjusting screw (3).
The temperature is preset at delivery to a value of 180 °C (360 °F).
After you have used the screwdriver, you can store it in a bracket on the right
side of the stand (2)
3.3
Setting the stroke limit
The stroke limit allows the front end position of the trigger to be adjusted.
This allows the user to
• achieve a comfortable trigger setting for himself or
• adjust precise metering of the adhesive for each working stroke
To set the stroke limit, please carry out the following steps:
1. Loosen the locknut (7a).
2. Adjust the setting screw (7) so that the trigger has the required initial positi-
on, or so that the required adhesive quantity is applied per working stroke.
3. Tighten the locknut (7a) to secure the setting.
1.
2.
3.
4.
230°
140°
180°
+
+
-
-
230°
140°
180°
+
+
-
-
Operation
GB
Summary of Contents for HB 325
Page 34: ...34 1 3 1 2 3 4 5 6 7 7a 8 9 RUS...
Page 35: ...35 2 2 1 1 200 C 2 2 1 2 4 8 RUS...
Page 36: ...36 3 2 1 2 3 3 1 1 2 5 5 3 3 4 4 8 3 2 3 9 180 190 C 2 3 3 1 7a 2 7 3 7a 230 140 180 RUS...
Page 37: ...37 3 4 3 5 3 6 20 25 5 3 7 1 2 3 1 4 RUS...
