Buildbotics
The Buildbotics CNC Controller is built for compatibility, ease of use, and performance. The hardware
and software are completely Open-Source.
Electrical Connections
The Buildbotics CNC Controller has a DB25 I/O port on the back for making a variety of I/O
connections. A DB25 breakout box is used for making connections to the DB25 connector, and is
included with the controller.
To
connect
the
Endura
nce
Laser
to the
Buildb
otics
Control
ler,
simply
connect
the
PWM+
wire
from
the
Laser Controller to the “Tool PWM” line found on pin 17 of the Breakout Box and connect the PWM-
wire from the Laser Controller to one of the Ground pins on the Breakout box (pin 7 is a good choice).
Then plug the DB25 Breakout board into the back of the Buildbotics Controller.
Configuration
