9
This machine is intended for use only by persons age over 16 who were trained by
authorized persons.
The equipment will be loaned only to persons who have been trained on its use and will be
always accompanied by User Manual.
Do not operate the brush cutter in case of bad weather (wind, rain, snow, ice)
Your power tool should be serviced by a qualified specialist using only standard spare parts.
This will ensure that it meets the required safety standards.
Application
The brush cutter is intended for personal use for cutting grass,bush,arborescent shrub,clumps,
wheat and similar plants.
IT IS NOT DESIGNED FOR PROFFESIONAL USE.
Description
1.Mixture tank.
2.Gas control with stop button
engine .
3.Carburetor/air filter.
4.Handle bar.
5.Anti-vibration support.
6.Gas control lever.
7.Transmission axle.
8.Gear box.
9.Cutting tool.
10.Safety guard
Accessories
1.Nylon head
2.Three teeth blade
3.Harvester head
4.Harness
5.Fuel mixture bottle
Assembly
Handle assembly
Fit the handle (4) on the transmission shaft (7) with the throttle lever on the right side and tighten
the 2 screws.
Mounting safety guard
This safety guard must be fastened on the Support near the gear case with the four screws and
the two plates.
1.Use of the nylon head: safety guard must be used with its two parts mounted,(main part of
different small black blade holder )
2.Use of the 3 teeth blade:must dismount tile small black blade holder.(with a screwdriver)and use
only the main part of the safety guard .
Harness
The harness provided is a model with foam and hip protection .It must be used with belt on the left
shoulder and the hip protection on the right side.
Balance of the machine
Before any use,you must adjust the harness in order to balance the machine as follows:
Place the belt on your left shoulder and hook to the machine .
