c.
If necessary, remove the front and rear rack doors.
d.
Mark the rack location where you will install the expansion unit, using one of the following
methods:
1)
If you have a rack-mounting template, use it to mark the location.
2)
If you do not have a rack-mounting template, complete the following steps:
a)
Face the front of the rack and work from the left side. Make a note of both the lowest and
highest EIA units to be used for the expansion unit. Use tape, a marker, or a pencil to mark
the bottom mounting hole
(A)
of the highest EIA unit. Mark the rack so that the mark can
also be seen from the rear of the rack.
Figure 1. Removing the filler panels
4
Power Systems: Installing the 58/02 and 58/77 expansion units
Summary of Contents for ESCALA Power7 5802
