iv
Fibre Channel Adapters Installation & Configuration Guide
Electronic Emission Notices
The following statement applies to this product. The statement for other products intended
for use with this product appears in their accompanying manuals.
Federal Communications Commission (FCC) Statement
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. Operation on this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own
expense. Shielded cables must be used between this equipment and attached peripheral
devices. The reader is cautioned that changes or modifications made to the equipment not
expressly approved could void the user’s authority to operate this equipment.
The above statement applies to products marketed in the USA.
Avis de conformité aux normes du ministère des Communications du
Canada
Cet appareil numérique de la classe A respecte toutes les exigences du Réglement sur le
matériel brouilleur du Canada.
Canadian Department of Communications Compliance Statement
This Class A digital apparatus meets the requirements of the Canadian
Interference–Causing Equipment Regulations.
European Union (EU) Statement
This product is in conformity with the protection requirements of EC Council Directives
89/336/EEC relating to electromagnetic compatibility, and with 73/23/EEC (Low Voltage
Directive).
Label:
Neither the provider nor the manufacturer can accept responsibility for any failure to satisfy
the protection requirements resulting from a non–recommended modification of the product,
including the fitting of option cards not supplied by the manufacturer.
This product has been tested and found to comply with the limits for Class A Information
Technology Equipment according to CISPR 22 / European Standard EN 55022. The limits
for Class A equipment were derived for typical residential environments to provide
reasonable protection against interference with licensed communication devices.
Summary of Contents for LP6000
