User Guide
215
www.bull.com
7.
Grasp the processor (use your index to hold the load plate side, and your thumb
to hold the lever side).
8.
Lift the processor straight and away.
9.
Set the processor immediately in its protective cover.
- Hold the CPU by three of its corners.
- The chamber of the protective cover should match the connection 1 on the
CPU.
- The rentention tabs on the cover and the processor contacts should point
each other.
Installing a CPU
1.
Remove the processor from its shipping materials, and, if applicable, remove
its protective cover.
Figure 167: Removing from the shipping materials
Caution
■
Do not touch the processor sensitive contacts.
■
Hold the processor by the substrate edges.
2.
Locate the connection 1 indicator and the two orientation key notches on the
CPU and on the socket.
3.
Grasp the processor with your thumb and index finger by the orientation key
notches.
4.
Carefully lower down the processor into the socket body.
Figure 168: Installing the processor
Summary of Contents for NovaScale R410 E1
