Bulldog Security DELUXE 200, Installation And Owner'S Manual

‘                                                                                                                                                                                                       ‘

‘

‘

22

23

PROGRAMMING

FEATURE #I PROGRAMMING CHART

One Chirp with

Press

One LED Pulse

Transmitter Factory Default Two Chirps with

Three Chirps with Four Chirps with

Button

Setting

Two LED Pulses

Three LED Pulses Four LED Pulses

1 

Chirps on

Chirps off

2 

0.8 second

3.5 second

Double pulse

Door lock with

door lock

door lock

unlock

“Comfort

pulse

pulse

Feature”

3 

Ignition 

Ignition

Ignition

Without

controlled

controlled

controlled

ignition

door lock 

door locks only door unlock

controlled

and unlock

only

door lock

and unlock

4 

Without this

Door lock

Door lock after Door lock

feature

before start

shut down

before start

and door lock

after shut

down

Exit: 

Turn Ignition to 

“ON”

 position, or leave it for 15 seconds. (3) long

horn chirps and (3) parking light flashes to confirm exit.

PROGRAMMING

A. PROGRAMMING A NEW TRANSMITTER:

Your  two-way  remote  transmitter  may  need  to  be  programmed  to  the

transceiver when you first install the unit. Please confirm that the antenna

transceiver is plugged into the control module before programming is attempted.

Note:

 The control module will only retain the last 4 remote transmitters

programmed. If the transmitter memory is exceeded, the security system

will  start  deleting  transmitters  from  memory  in  chronological  order.

1. Turn the Ignition switch from 

“OFF” to “ON” (3) times

 and leave in the

“ON” position

.

2.

Within 15 seconds

, push the 

valet/program switch

(3) times

 and 

on the 

3rd push hold it

 in until a long chirp from horn then release the

valet/program switch

. You are now in the 

transmitter programming

mode.

3. Press and hold any button on the transmitter until 

(1) chirp

 from the

horn and 

(1) flash

 from the parking lights confirming the first transmitter

is now programmed.

4. If you have additional transmitters

 (up to 4)

 that need to be programmed,

repeat step 3 for each transmitter.

B. FEATURES PROGRAMMING:

ALARM FEATURE. #1 PROGRAMMING:

1. Turn the Ignition switch from 

“ON” to “OFF” (3) times

 and leave in

the 

“OFF”

 position.

2. Push the programming switch 

(2) times

 and on 

2

nd

push hold it until 

(1)

chirp

 followed with a long chirp is heard, then release the switch.

You are now in the 

“alarm feature #1 programming mode”.

3. Press and release the transmitter button that corresponds to the feature

you desire to program.

a. The amount of horn chirps and LED pause will indicate the previous

    setting.

b. The factory default settings will always be 

(1) LED flash

 and

 (1)

horn chirp.

4. Press the transmitter button again to change the feature. Simply keep

pressing the transmitter button until the module advances to your

desired programming setting.

Example:

a. After you hear

 (1) chirp

, press the button again and the module will

   advance to 

(2) LED flashes

 and 

(2) horn chirps.

    b. Press the button again, the module will advance to 

(3) LED flash

        and 

(3) horn chirps

 etc.