INSTRUCTIONS FOR USE OF YOUR SHUT-N-CUT
Insert knife
in slot
• Press the red trigger to unlock the clamp arm. Pivot
the clamp arm to the full‑open position.
• Set insulation on the lower clamp bar so that the
cutting slot is in-line with the desired cut.
1
1
2
2
• Close the clamp arm to compress the product,
pressing down on handle until the trigger engages.
• Insert the Centerfire Insulation Knife (included)
into the cutting slot on the clamp arm.
• Cut through the insulation product with a sawing
motion, drawing the blade toward you.
PRT‑INS‑1950 RevA.1.19 ©2019 Bullet Tools
For warranty info, accessories, & tips on
using and maintaining your Shut-N-Cut,
go to BulletTools.com
Hayden, ID USA • 208-772-0175
SAFETY
1) This machine has several
pinch points. Do not adjust
or collapse machine when
fingers are in the way.
2) To avoid tipping and/or
rocking, only operate on a
level, stable, flat surface.
3) Wear safety goggles and all
other OSHA recommended
safety gear when cutting.
INSULATION
45
o
NOTE: The CenterFire Straight
Blade works best when
held at a 45o angle to the
product.
