www.BulletTools.com | 800 - 406 - 8998 | 3390 W Hayden Ave, Hayden ID 83835
EZ SHEAR
™
SST 20
6
MAKING CUTS
The EZ Shear™ is operated manually. The two-part handle is grasped by the operator and pushed down
to make a cut.
ALWAYS KEEP HANDS / FINGERS AWAY FROM THE BLADE!
CUTTING
1.
Unlock safety lock by sliding knob over and down.
2.
Insert material. It is recommended that you HOLD MATERIAL IN PLACE until the cut is complete.
3.
PUSH HANDLE DOWN TO CUT. Some effort may be required depending on hardness of material.
4.
CAUTION: Handle is spring loaded.
DO NOT ALLOW HANDLE TO SLAM BACK AFTER MAKING A CUT.
TIP: DOUBLE CUTTING
Most materials (listed on p. 10) shear very well with just one
cut. However, some brands of laminate flooring and other
products may require cutting twice to produce a better cut.
Simply make your first cut 1/8" to 1/4" (3 to 6mm) longer
than your mark, then go back and make your second cut on
your mark. This is very useful to create a cleaner cut when
trim cannot be used to cover your cut end.
USE EXTREME CAUTION! Blade is very sharp.
!
SAFETY LOCK
For maximum security, the safety lock will automatically
reset in the "locked" position unless disengaged. The safety
lock can be disengaged by sliding the knob over and down,
hooking into slot. (Shown Right)
TRANSPORT
It is important to re-engage lock and secure handle in
down position while storing, carrying, or transporting your
EZ Shear™.
Locked
Unlocked
CUSTOM SETTINGS
THE ANVIL
The Anvil has two edges: a 1/32" (0.75mm) narrow edge and a
3/16" (4.5mm) wide edge. Either edge can be used according
to the support needed to make a clean cut. (Some soft-backed
products require the wider anvil edge).
TO CHANGE
BETWEEN EDGES
Simply remove the anvil screws and flip the anvil over. Ensure
blade stop is in place.
TABLE
I-BEAM
ANVIL
BL
ADE
BL
ADEST
OP
TABLE
I-BEAM
ANVIL
BL
ADE
BL
ADEST
OP
TABLE
I-BEAM
ANVIL
BL
ADE
BL
ADEST
OP
TABLE
I-BEAM
ANVIL
BL
ADE
BL
ADEST
OP
