1. Install Support Planks
At the start of every floor, cut two support planks of flooring to about
3 inches (75mm) wide and about 20 inches (500mm) long.
Set the support planks about 1/4” (6mm) from the blade, with the
tongue sides facing toward the center of the table and spaced apart
by at least the width of material you are installing.
Clamp the support planks in place using the clamp knobs. (A)
Paladin Hardwood Cutter MS93-1009
QuickStart Guide
Warning:
DO NOT OPERATE WITH
AIR PRESSURE ABOVE
125PSI (8.6 Bar)!
2. Air Supply
Connect compressed air to the air
inlet. Ensure that the pressure is
regulated to between 80 and 125 PSI.
Disconnect air supply before
servicing and when not in use.
a
C
A
U
T
ION
Hydraulics can
easily crush bone!
Keep all
appendages
clear of moving
components.
High pressure
hydraulic fluid can
cut through skin!
Cut power and
depressurize
hydraulic system
before servicing
hoses or fittings.
The blade is
extremely sharp!
Keep hands clear
of blade when
operating or
servicing.
1/4” (6mm)
From
Blade
