CCD-Premium
Operating manual
page 18 /24
Detailed Instructions
Control unit and mechanics
Power supply
The machine power supply has a wide range AC input. You can run it on any common single phase
mains supply. If the power cord supplied with the machine is not suitable for your country, please re-
place it. In this case it is urgently required that you ensure correct grounding to PE.
Attention!
You must disconnect the machine from
the main supply and wait until DC voltages are low
prior to opening the control unit or to pulling cards
off from it. We deny any liability if alterations to any
mechanical, electric or electronic components of
the machine are made. Prior to any manipulation to
the control unit, check that the machine has been
disconnected from the main supply. Inside of the
controller box are no parts which shall be set by the
end user. Potentiometers are factory set and may
not be changed. Do not pull any plugs while the
machine is under current. First switch off machine
and wait for equipotential.
Mechanics Unit
Set up
Put the machine onto a stable, even table and ad-
just the machine's 4 feet by turning them. A stable
desk and a proper setting are important to prevent
vibrations etc.
(ATC) Compressed air connection
The machine requires compressed air of at least 6 bar to open and close the spindle chuck and to sup -
ply the spindle with sealing air. The continuous air flow prevents dust from entering the spindle and so
enhances the lifetime of the spindle. A compressor is not included with the machine, but an air hose is.
On the right is the air valve with a pressure reducer. Connect the air hose´s free end to that valve. The
other end of the hose has a standard connector for compressed air outlets.
Vacuum cleaner
At the power supply there are two so called
Schuko-sockets. Insert into these sockets devices
that shall turn on together with the spindle, e.g. the
vacuum cleaner or a magnetic valve for the cooling
device. Please note, that the maximum power
taken from these sockets may not exceed 6 A!
The machine was delivered with a small vacuum
cleaner. After electrical connection you can place
the cleaner behind or under the machine and con-
nect the vacuum tube with the adaptor of the suc-
tion pipe of the machine.
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/5036, Fax: +49 (0) 2292/6175, E-mail: support@bungard.de
