rdc-30-manual-en
Page 4 /
Intended Use
The machines are designed for coating positive and negative photoresists and solder masks as
well as other paints or SolGel liquids.
All other applications require our written consent or are at full risk of the user. Bungard GmbH &
Co. KG assumes no liability whatsoever for any damage that may result from the use of the ma-
chine.
Safety Regulations
Please apply the general safety rules for working with electrical machines.
There are no tools needed to operate the machine. With any intervention on the machine the war -
ranty will void.
Do not run the machine in corroding, humid, dusty, extremely hot or explosive atmosphere.
If you do run the machine in an atmosphere as described above be aware that this happens
on your own risk and responsibility.
The operator has to provide appropriate safety precautions and equipment. We explicitly exclude
any warranty for damages resulting from running the machine in an atmospheres as described
above.
Important: the motor holds the lift bar only when the power supply is switched on. Mount items
only to the holder with power on. Otherwise the lift bar will move downwards. The maximum load
is 2 kg at maximum speed.
Do not remove cabling while the machine is turned on! Turn off the machine and wait for
equipotential.
Please take great care when adjusting stroke length and speeds. Consider the height of the
liquid container and additional stirring devices. If the value of virtual offset, distance drive
and dip drive is higher than the stroke length (normally 575mm), then this will result in step
loss during the first drive down.
We do not warrant damages caused by wrong settings.
Do not run the machine unattended.
Be careful not to spill liquid over the turning table. This may effect mechanics and electronics.
Setup
Examine the machine for possible transport damages. If you en-
counter any problems inform us and the carrier immediately.
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/9 28 28 - 0, Fax: +49 (0) 2292/9 28 28 - 29, E-mail: support@bungard.de
