18
Instruction manual
© 22.02.2017 Bungard GmbH & Co. KG
4.7
Optional accessories
4.7.1
Frame
There are various frames available for holding stencils
The various frames are listed in the following:
4.7.1.1
Stencil holder frame
The simplest way of holding a stencil for the stencil printer is the stencil holder frame.
903.203 - Stencil holder fr am e
It is meant to hold the stencil in place without having to use clamps.
The holder frame was developed for the holding of so-called “prototype stencils”.
o
These are frequently available from PCB suppliers at low cost.
Due to the fact that the “prototype stencils” are slightly larger than the PCB to be printed
and that they have no holes for holding them, the stencils are held in place by clamping.
Important
Depending on the size of the stencil, the parallel stencil lift cannot be used
optimally.
Attention
No guarantee can be provided that all available “prototype stencils” can be
held in place with the stencil holder frame..