Bunker Hill Security 95914, Owner'S Manual

Page 6

For technical questions, please call 1-800-444-3353.

SKU 95914 

Mounting

The Security Camera can be mounted with the Camera Base, so 

that its position is adjustable, or the base can be removed and the 

Camera can be mounted in a stationary position.  If the camera is to be 

mounted outdoors, do not use the adhesive pad for attachment.

Mounting the Camera with the Base

1. 

Figure C 

Camera (1)

Camera Base

Screwdriver

Adjust the Camera to the desired angle:

a. Insert a Phillips head screwdriver 

(sold separately) into the center of the 

Camera base and loosen the bolt.

b. Adjust the angle of the Camera, 

then tighten the bolt.

2. 

Figure D 

Camera Base

Screw

Screwdriver

Mount the Camera to the 

chosen location, using the three 

included bolts through the three 

holes in the Camera Base.

WARNING!

 Check for hidden 

wiring before securing.

Note:

  The adhesive pad can be used 

instead of the screws for indoor locations.  

Do not use adhesive pad to mount 

outdoors, it is not weatherproof.

Mounting the Camera without the Base

1.  Using a Phillips head screwdriver 

(sold separately), unthread the two 

screws that hold the Camera Base in 

place and remove the Camera Base. 

Store in a dry safe place. 

2.  Use the holes on the back of the 

Camera to secure the unit in place. 

Note the angle of the holes 

when planning any drilling.

Rev 07i, 08j, 10a, 10l