background image

Never use any fuel-burning products (stoves, lanterns, heaters, 

etc.) inside or within proximity of the Bunker. Use of fuel-burning 

products inside or within proximity of the Bunker can result in the 

accumulation of dangerous concentrations of carbon monoxide 

– a colourless, odourless and tasteless gas that is slightly denser

than air. Breathing carbon monoxide could cause serious injury

or death.

Keep all flame and heat sources away from this Bunker. This 

Bunker is made with flame resistant fabric but it is not fireproof. 

The Bunker fabric will burn if left in continuous contact with an 

open flame or other heat source. Failure to keep all flame and 

heat sources away from this Bunker may result in a fire that could 

cause serious injury or death.

Before   using   this   product,   read   and   fully    understand:

(1) attached warnings; (2) the Owner’s Manual and all

accompanying documentation. Failure to follow these directions 

could cause an unsafe situation leading to fire, burns, severe

injury, or death.

WARNING

USING AND CARING

VENTILATION

Maintain adequate ventilation inside the Bunker at all times.

CAMPSITE CHOICE

When choosing a campsite, carefully consider the possibility of 

falling rocks or tree limbs, lightning, flash floods, avalanches, 

strong winds, and other potential hazards, to reduce the risk of 

loss or injury.

Select a site that’s level, well drained, and is protected from the 

wind and other elements. Clear the campsite of sharp stones, 

sticks, and other debris

If possible, avoid setting the Bunker on 

ground that is already wet. If this is not possible keep the 

Bunker well ventilated to minimize humidity and condensation 

within the Bunker.

PEGS AND ROPES

Peg down the Bunker properly at all times to reduce the risk of 
loss or injury to Tent users.

All Bunkers require pegging to prevent them from being blown 

away in strong winds. Always anchor the Bunker. Tent pegs and 

ropes are supplied to safely setup the Bunker in most situations.  

It may be necessary to purchase additional and/or specialized 

pegs and ropes for use in extreme or varied soil conditions. 

Tightly tensioning the Bunker with attached ropes greatly 

increases the Bunker’s strength and stability. This will also reduce 

fabric sagging and wrinkles and prevent rainwater from pooling.

Summary of Contents for LITE









Reviews: