15
P2210.30
1. Hopper Lid
2. Agitator Disk Assy
3. Auger Drive Shaft
Bushing
4. Mixing Blade
5. Auger Drive Shaft
6. Auger Shaft Coupling
7. Locknut
8. Hopper
9. Auger Wire
10. Ejector Elbow
11. Auger Motor Mount-
ing Panel
12. Auger Drive Coupling
13. Auger Motor
14. Dust Seal
15. Shoulder Screw
16. Hopper Support plate
17. Coupling Spring
18. Hex Coupling
FIG. 5 AUGER DRIVE & HOPPER DISASSEMBLY
SERVICE (CONT.)
AUGER DRIVE COMPONENTS
Auger Drive Motor (Refer to Figs. 5 thru 9)
1. Remove all hopper assemblies and set aside for
reassembly.
2. Remove the four #8-32 screws securing the hopper
support plate (16) and set aside for reassembly.
P1639
FIG. 6 AUGER MOTOR TERMINALS
3. Remove the #8-32 locking screws, located inside
the dispenser housing on the front of the auger
motor mounting panel (11), securing auger motor
(13) to the rear of the auger motor mounting panel
(11).
4. Disconnect the wires from the auger motor (13) to
be removed.
5. Disconnect RPM sensor plug.
6. Remove auger motor (13) and dust seal (14) as an
assembly.
7. Remove dust seal (14) from auger motor (13).
8. Remove the #8-32 screws securing the auger motor
to the auger motor mounting bracket.
9. Remove auger motor and discard.
10. Using #8-32 screws, install new auger motor (13)
on mounting bracket (11).
11. Install dust seal (14) on auger motor shaft.
12. Using #8-32 locking screws install auger motor and
dust seal to the rear of the auger motor mounting
panel (11)
13. Reconnect the wires to the terminals on the auger
motor.
14. Reconnect RPM sensor plug.
15. Install hopper support plate (16) and all hopper
assemblies.
16. Refer to Fig. 6 when reconnecting wires.
1
4
2
3
5
8
16
9
10
12 7
6 17
18
11
15
13 14
BLK (-)
RED (+)
4-24 VDC
42032 060109
Summary of Contents for IMIX
Page 10: ...10 42032 060109 NOTES ...
Page 46: ...46 42032 060109 ...
Page 48: ...48 42032 060109 ...