9
INITIAL FILL (cont)
Ambient Concentrates (Optional)
1. Install an Ambient Concentrate Conversion Kit (BUNN-O-MATIC part number 33699.0000) per the instruc-
tions provided in the kit.
2. Attach the concentrate product hose to the appropriate concentrate line located behind the dispenser’s splash
panel.
3. Attach the other end of the product hose to the product container through an appropriate fitting.
PRIMING
1. Open the dispenser door
2. Load concentrate per instructions in section titled Loading.
3. Close the dispenser door.
Note: The dispenser will not operate with the door open.
4. Place a large container under the appropriate dispense nozzle.
5. Dispensers with Press and Hold Feature:
Press and hold the “Product Dispense Switch” Fig 4, until concentrate dispenses from the dispense
nozzle.
Dispensers with Portion Control Feature:
Press and hold the “+/STOP Switch” Fig 5, until concentrate dispenses from the dispense nozzle.
Note: This may take several seconds, depending on the installation and programmed pump speed.
38218.1 030306
DISPENSER USE
Press and Hold Models (Refer to Fig 4)
1. Place a cup on the drip tray beneath the desired dispensing nozzle.
2. Press and hold the “Product Dispense” or “Chilled Water” switch until the beverage/water reaches the desired
level, then release.
Portion Control Models (Refer to Fig 5)
1. Place a cup on the drip tray beneath the desired dispensing nozzle.
2. Momentarily press the appropriate cup size switch to dispense the beverage. The dispenser is factory preset
to produce the approximate beverage sizes as follows:
Small (4.0 seconds): approximately 7 fl.oz. (207 ml)
Medium (6.9 seconds): approximately 12 fl.oz. (355 ml)
Large (9.1 seconds): approximately 16 fl.oz. (473 ml)
The dispense times can be individually programmed by following the procedures described in ADJUST-
MENT - Cup Size Programming.
To stop a timed dispense, momentarily press the “+/Stop Switch”.
3. To “top-off” a beverage, press and hold the “+/Stop Switch” until the beverage reaches the desired level, then
release.
4. To dispense chilled water, press and hold the “Chilled Water Switch” until the water reaches the desired level,
then release.
