Bunn LCR-2, Installation And Operating Manual

17

36026 120105

MENU SCREEN 

 ACTION 

   DESCRIPTION

CAL  LEFT  PUMP ?

PULL DISPENSE

CAL LF PUMP VOL

(-)     43mL     (+)

CAL  LF WTR FLOW ?

PULL DISPENSER

CAL LF WTR VOL

(-)     36.0OZ     (+)

CAL  LEFT SIDE ?

      EXIT   YES 

CAL  RIGHT SIDE ?

      EXIT   YES

If NO - go to CAL RIGHT SIDE menu.

CAL  LEFT SIDE ?

      EXIT   YES 

The following functions are for diagnostic and troubleshooting purposes and typically do not have to be 

adjusted. Contact your local service agent for assistance before making changes to these functions.

RINSE TIME  ?

(-)   12 Hrs   (+)

RINSE LOCKOUT ?

NO  EXIT  YES

BIB EMPTY LOCKOUT

NO  EXIT  YES

BREW LOCKOUT ?

NO  EXIT  YES

DLY REPEAT DISP

(-)     0 SEC    (+)

Place a 50 mL (#34843.1000) 

graduated cylinder under the 

Left dispense tip, then activate 

the Left Dispenser

Use the (+) or (-) buttons to 

enter volume collected

Place a 64 Oz. (2000 mL) 

container under the Left 

dispense tip, then activate the 

Left Dispenser

Use the (+) or (-) buttons to 

enter volume collected

NONE

Select (YES) to enable 

Calibration routine.

Select (YES) to enable

Use the (+) or (-) buttons to 

adjust Rinse Alarm delay

Select (YES) to enable

Select (YES) to enable

Select (YES) to enable

Use the (+) or (-) buttons to 

adjust the Delay Time

The Left Pump will dispense concentrate for 20 

seconds, then shut off automatically. Collect and 

measure the concentrate dispensed. 

Enter the volume of concentrate measured from 

the Left Pump in mL, (not Oz.) regardless of 

Preferred Units selected.

The Left Dispenser will dispense hot water for 20 

seconds, then shut off automatically. Collect and 

measure the water dispensed.

Enter the volume of the water measured from the 

Left dispenser in Oz. (mL).

Scroll down to bypass this screen.

Selecting Yes will enable the Right Dispenser 

Calibration routine, (see Pump Calibration) prior 

to calibrating the dispenser.

Selecting Yes will enable the Left Dispenser 

Calibration routine, (see Field Calibration before 

attempting to calibrate the dispenser).

Enter the desired time between required Rinse 

Cycles in hours, [8 - 24 hrs.]

Select YES to Lockout dispensing until the Rinse 

Alarm has been cleared. Default is NO

Select YES to Lockout dispensing until the 

Concentrate BIB has been replaced. Default is 

NO

Select YES to Lockout dispensing until the hot 

water tank is at READY Temp. Default is NO

Enter the desired time delay before allowing the 

next dispense to take place, [0 - 10 sec.]