Bunn LCR-2, Installation And Operating Manual

19

MENU SCREEN 

 ACTION 

   DESCRIPTION

36026 073107

BIB EMPTY -> 500

(-)     EXIT     (+)

XX   REFILL -> 155

(-)   EXIT   (+)

WTR START DELAY

(-)  .15SEC  (+)

WTR STOP DELAY

(-)  .15SEC  (+)

TEST LED’S  ?

NO   EXIT   YES 

TEST SWITCHES  ?

UseSwitchToTest

TEST REFILL  ?

         EXIT  YES

TEST  HEATER   ?

         EXIT  YES

ENTER ASSET #

(-) 000000 (+)

SERIAL #

LCR 0000000

VIEW FAULTS?

(-)     EXIT     (+)

LATEST FAULT

NO FAULTS

FACTORY DEFAULTS

NO         YES

Use the (+) or (-) buttons to 

adjust empty BIB threshold

Use the (+) or (-) buttons to 

adjust Refill threshold

Use the (+) or (-) buttons to 

adjust delay time

Use the (+) or (-) buttons to 

adjust delay time

Select (YES) or (NO)

NONE

Momentarily depress (YES)

Momentarily depress (YES)

Use the (+) or (-) buttons to 

adjust the ASSET NUMBER

NONE

Select (+) to view Fault 

Conditions

Use (+) or (-) to scroll through 

the Faults

Select (YES) or (NO)

Used to set the Conductance Threshold for the 

Empty BIB warning. Default is 500

Used to set the Conductance Threshold for the 

Tank Refill Probe.

Dispense Valve ON Delay. Eliminates weak mix 

at the beginning of a dispense.

Dispense Valve OFF Delay. Flushes the mix 

chamber at the end of a dispense.

LED diagnostics. Selecting YES will light all Front 

Door LED’s.

Switch Diagnostic: Activate switches separately to 

test. Display will indicate which Switch has been 

activated. NOTE: Door Interlock switch must be 

held closed.

Refill Valve Diagnostic: Press YES to momentarily 

energize the Solenoid. CAUTION: Inlet Valve will 

open and water will flow, if connected and turned 

ON.

Tank Heater Diagnostic: Press YES to momentarily 

energize the Tank Heater Circuit.

CAUTION: AC power will be applied to the Tank 

Heater Circuit.

Allows the user the option of entering an Asset 

Number. Default is 000000

Displays the manufacture’s Serial Number (should 

be identical to the Serial Number on the machine 

Data Plate)

This unit stores the last 3 Fault Conditions in 

memory for diagnostic purposes.

Displays up to 3 FAULT Conditions or NO FAULTS, 

if nothing has failed since the last “Reset Factory 

Defaults”.

CAUTION: Selecting YES will RESET all 

Programming Functions to the Factory Default 

settings.