Bunn MCPA, Use And Care Manual

13

8)  When the cycle has finished, empty the cup. Repeat step 7 at least two more 

times to remove the solution from the tank.

9)  Clean the pod holder with a mild detergent and rinse thoroughly.

10)  Proceed to the “Cleaning The Sprayhead/Seal” section.

CLEANING THE SPRAYHEAD/SEAL

1)  Press the Power Switch into the off “O” position. 

2)  Unplug the brewer and allow it to cool down. (Minimum of 1 hour.)

3)  After the unit has been allowed to cool, remove the pod holder and set aside.

4)  Using your fingers, rotate the sprayhead/seal assembly 

clockwise until the sprayhead and seal are removed.

NOTE:

 If the sprayhead and seal are separated, they must be 

reassembled as they were when removed from the brewer. 

CAUTION:

 Improper reassembly could result in personal 

injury from scalding water. 

NOTE: 

See “Assembling Sprayhead/Seal” (Page 13) & 

“Inspecting Sprayhead Seal” (Page 14) for more information.

5)  Clean the sprayhead and seal with a mild detergent and 

rinse thoroughly.

6)  Using your fingers, rotate the sprayhead/seal assembly counter-clockwise until 

it is finger tight.

7)  Replace the pod holder.

8)  Plug in the brewer and press the POWER SWITCH to restore power to the 

brewer.

ASSEMBLING THE SPRAYHEAD/SEAL

If the sprayhead and seal are separated during removal or cleaning, they must be 

reassembled properly.
1)  Identify the top of the seal. The top of the seal that seats 

against the roof of the sprayhead ramp has a  rough 

ridge that can be felt by running your fingers across the 

surface of the seal. The bottom is smooth.

2)  Identify the top of the sprayhead. The top of the 

sprayhead has a star pattern and a threaded hole where 

the sprayhead attaches to the brewer. 

3)  While carefully stretching the seal, guide the sprayhead 

into the channel of the seal.  Make sure it is completely in 

the channel.

  When properly assembled, the sprayhead will slide easily 

into the channel of the seal and will not cause any buckles in 

the surface of the seal. If the sprayhead seems to be difficult 

to seat, and you must stretch the seal more than a slight tug, 

the assembly is not together correctly.

CAUTION: 

Improper reassembly could result in personal 

injury from scalding water.

Top

Top

P2953

P2953

P2953

PERIODIC CLEANING/DESCALING (Cont.)

P3015