Page 10
PROGRAMMING
49063.2 032014
Setting the Large and Small Brew volume:
1. Press and hold the Large (to adjust Large brew)or Small brew switch (to adjust Small) for 5 seconds
while
the brew chamber is open
. During that time the red/green LEDs will fl ash rapidly. After 5 seconds the leds
will turn off.
The large batch switch will increase the volume and the small batch switch will decrease the volume.
2. If setting the large batch, each time the large or small switch is pressed, the red led will momentarily fl ash.
3. If setting the small batch, each time the large or small switch is pressed the green led will momentarily fl ash.
4. Each time the switch is pressed, the volume is increased or decreased by .25 Ounces.
If the maximum volume (16.0) or the minimum volume (4.0) is reached, the red LED will fl ash rapidly for the
large volume. The green LED will fl ash rapidly for the small volume.
DEFAULTS: 8oz/6oz
If no switches are depressed for 10 seconds -- the setup mode is exited
Changing the temperature set point between high altitude (190° F) and low altitude (200° F) (default = 200° F):
1. Press the Large brew switch 5 times (within 5 seconds) with the brew chamber open. This will cause the
temperature to toggle modes. If the New temperature is 190 degrees, the red LED will fl ash 5 times. If the
New temperature is 200 degrees, the red LED will fl ash 10 times.
Enabling or Disabling the Energy save mode:
1. Press the Small brew switch 5 times (within 5 seconds) with the brew chamber open. This will cause the
energy save to toggle modes. If the new mode is energy save enabled, the green Led will fl ash 5 times. If the
new mode is energy save disabled, the green Led will fl ash 10 times.
Restoring the factory defaults:
1. Turn off the main power switch.
2. Press and hold both Large and Small batch Switches and turn on power switch. Continue pressing both
switches for 5 seconds.
3. After 5 seconds, the red and green LEDs will fl ash rapidly for 5 seconds, the operator must release and
press both the Large and Small Batch switches within 5 seconds. The red and green LEDs will turn off for
approximately 5 seconds and then turn on and off 5 times indicating success.
