Page 8
CUP HOLDER
1. Disconnect brewer from power source and allow to cool.
2. Open the cup holder.
3. Remove cup holder by squeezing it to one side and
lifting out.
4. Wash and rinse cup holder. Verify holes are cleared.
CAUTION: CUP CONTAINS A SHARP NEEDLE.
5. Wipe off rubber seal under cup holder.
6. Install cup holder back into housing.
CLEANING
The use of a damp cloth rinsed in any mild, nonabra-
sive, liquid detergent is recommended for cleaning
all surfaces on Bunn-O-Matic equipment.
DRIPTRAY
1. Lift the driptray cover straight up.
2. Pull the driptray out and clean as needed.
49063.2 032014
SCREEN
1. Disconnect brewer from power source.
2. Remove reservoir cover.
3. Pull screen assembly up by either of the two tabs.
4. Wash and rinse as needed. Push back down
until rubber ring is fl ush with reservoir bottom.
5. Install reservoir cover.