Page 7
COFFEE BREWING
Start each brew cycle with an empty, clean, half-gallon decanter.
1. Insert a BUNN® filter into the funnel.
2. Pour the fresh coffee into the filter and level the bed of grounds by gently shaking.
3. Slide the funnel into the funnel rails.
4. Place the On/Off brew station warmer switch in the upper position.
5. Momentarily press the start switch.
6. When brewing is completed, simply discard the grounds and filter.
MODEL RT
D E
A B C
F G A B C H I
P1687
P1688
NEEDLE VALVE ADJUSTMENT (Models with Faucet)
This brewer is equipped with a unique faucet system allowing hot water to be drawn-off a cup-at-a-time for
instant beverage needs, even while brewing.
WARNING -
Disconnect the brewer from the power source before the removal of any panel or replacement of
any component.
ADJUSTMENT
1. Disconnect the brewer from the power source and remove the front inspection panel located beneath the
brew funnel.
2. Adjust the needle valve as required to increase or decrease the pressure of the hot water flowing from the
faucet. Turn the propeller on the valve in a counterclockwise direction to increase the flow and in a clockwise
direction to decrease the flow.
3. Reconnect the brewer to the power source and allow the water in the tank to heat to the proper temperature
before operating the brewer.
32440 121699
CLEANING
1. The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all
surfaces on Bunn-O-Matic equipment.
2. Check and clean the sprayhead. The sprayhead holes must always remain open.
3. With the sprayhead removed, insert the deliming spring (provided) all the way into the sprayhead tube. When
inserted properly, no more than two inches of spring should be visible. Saw back and forth five or six times.
Then, repeat this step for the air vent tube.
NOTE -
In hard water areas, this may need to be done daily. It will help prevent liming problems in the brewer
and takes less than a minute.
MODEL OT
Part II
Summary of Contents for OL
