USE & CARE INFORMATION
INTRODUCTION
These dispensers are designed to hold and serve either a three and a half, four or five gallon batch of iced tea
or iced coffee, depending on the model. When proper precautions are followed, tea/coffee may be brewed directly
into the dispenser and then transported to a remote serving location. The dispenser must be placed on a sturdy
counter or shelf.
* CAUTION: YOU MUST BE CAREFUL WHEN LIFTING THESE DISPENSERS. WHEN THE DISPENSER IS HOLDING
LIQUID.
* CAUTION: LIFT THE DISPENSER USING THE HANDLES ONLY.
* CAUTION: DO NOT LIFT THE DISPENSER FROM THE BOTTOM.
CAUTION: DO NOT USE FAUCET AS HANDLE.
* NOTICE: DO NOT BREW INTO PLASTIC LINER BY ITSELF (If equipped) IT MUST BE IN IT’S STAINLESS STEEL
HOUSING.
* NOTICE: DO NOT USE BREW THROUGH LID WITH POUCH PACK FUNNELS WHEN BREWING INTO TD3T-N.
* NOTICE: DO NOT OVER TIGHTEN FAUCET WING NUT. HAND TIGHTEN ONLY
Failure to observe caution may result in personal injury.
TDO/N-3.5 dispenser weighs approximately 35 pounds when full.
TDO/N-3.5LP dispenser weighs approximately 33 pounds when full.
TDO/N-2.0LP dispenser weighs approximately 31 pounds when full.
TDO/N-4 dispenser weighs approximately 48-50 pounds when full.
TDO-5 weighs approximately 59 pounds when full.
TDS-3S & ICD-3S weigh approximately 40 pounds when full.
TDS-5S weighs approximately 55 pounds when full.
TD4/TD4T
These dispensers are designed to hold and serve up to 4-gallons of iced tea or iced coffee.
TD4T-DR
These dispensers are designed to hold and serve up to 2 gallons of cold beverage in each of two
reservoirs at remote locations. Two separate reservoirs, each having its own faucet, means you can now serve two
different kinds of beverage. Easy to see indicators on the front of the dispenser shows when a refill is needed to
either reservoir.
45301.3 092215
