11
I Englsih
secuENTRY HOME 5000 CYL
Programming/updating the cylinder
The cylinder must be programmed
accordingly so that the registered users
can now open the lock with the stored
opening options. Program the cylinder
as follows:
Open the main menu (Fig.
67).
Tap on the menu item
"secuENTRY setup"
(Fig.
68).
Tap on
"Programming"
in the submenu (Fig.
69).
The list of programming
fi
les appears.
This is where the required changes are
generated in programming
fi
les and
collected for sending to the cylinder. By
default, the list is empty because there
is no collection. If there are still earlier
programming
fi
les in the list, delete
them by sliding the respective entry
from right to left (Fig.
70).
Tap the "+" at the top right to add your
required changes or the corresponding
cylinder to the list (Fig.
71).
Select the cylinder for which you have
set up changes (I) (Fig.
72).
Note:
If you have several cylinders and
have created changes for each, please
only select the cylinder within the Blue-
tooth range of which you are located.
Then tap on
"PROG.FILE"
(II) at the top
right (Fig.
72).
1
2
3
4
5
Fig.
69
Fig.
71
Fig.
67
Fig.
68
Fig.
70
Select the programming
fi
le that is
now in the list (I) and tap on
"Program
(update) unit"
(II) (Fig.
75).
Note:
If you have generated several
programming
fi
les for several cylinders,
please only select the cylinder within
the Bluetooth range of which you are
located.
Once again you will be prompted to
enter your administrator code (Fig.
76).
After entering the code (I), keep your
smartphone close to the cylinder
(max. 2 m) and tap on
"START"
to start
programming (II).
The loading window indicates that pro-
gramming has started and the current
status of the programming (Fig.
77).
As soon as the programming has been
completed successfully, you will receive
a corresponding feedback. Con
fi
rm the
name with
"OK"
(Fig.
78).
If the process failed, repeat the steps
starting from step 6.
9
10
12
13
11
Fig.
76
Fig.
77
Fig.
74
Fig.
75
I
I
II
II
!
You will then be prompted to enter
your admin code (I) and con
fi
rm with
"OK"
(II) (Fig.
73).
A message appears stating that the
programming
fi
le has been generated.
Con
fi
rm the name with "
OK
" (Fig.
74).
6
7
8
Fig.
72
Fig.
73
I
II
I
II
!
Fig.
78
14
15