16
I Englsih
secuENTRY HOME 5000 CYL
ENTRY 7711 Keypad PIN installation - adhesive mounting
1
2
Clean the surface to which the keypad
is to be attached (Fig.
113).
Attach the enclosed adhesive pads to
the positions shown in the illustration
and peel o
ff
the backing strips
(Fig.
114).
Mount the keypad on the wall in the
desired position (Fig.
115).
Press the keypad against the wall for
approx. one minute (Fig.
116).
Attention:
Only press the outer edges of the
housing. To avoid damage to the
electronics, do not press within the
keypad area.
Fig.
113
Fig.
114
Fig.
115
Fig.
116
3
4
!
!
1 Min.
Battery status display and replacing the batteries
ENTRY 5000 CYL
cylinder
The battery status is shown on the
display each time a secuENTRY cylinder
is activated via the KeyApp (Fig.
117).
When the batteries in the cylinder are
running low, replace them as soon
as
possible.
Attention:
The batteries are located
in the cylinder knob on the
inside
of
the door. Please note that if you ignore
the battery status and the battery is
completely discharged,
you will no
longer be able to open the lock from
the outside.
Instructions on replacing the batteries
are given below:
On the inside of the door at the front
end of the knob, remove the screw
with the TX8 screwdriver provided and
remove the front cover (Fig.
118).
Remove the old batteries and dispose
of them appropriately.
Tip:
Instructions for proper disposal can
be found on page 17 of this manual.
Insert two new batteries. Make sure that
the polarity is correct according to the
drawing (Fig.
119).
Replace the front cover and screw it on
tightly (Fig.
120).
Fig.
117
!
!
2
3
4
1
Fig.
118
Fig.
119
Fig.
120
