15
I Français
secuENTRY KeyApp - iOS
QR
Montage de l’ENTRY
7711
Keypad
PIN
Montage de l’ENTRY
7711
Keypad
PIN – Test de fonctionnalité avant le montage
Vous trouverez ci-après les instructions de montage de l’
ENTRY
7711
Keypad
PIN
.
Vous avez le choix entre deux options pour l’installation. Vous pouvez
boulonner
le support
mural de l’
ENTRY
7711 Keypad PIN
ou le
coller
directement au mur.
Veuillez lire ces instructions attentivement avant de procéder au montage.
!
1
2
ATTENTION
:
Techniquement, la distance entre le
cylindre et le clavier peut être de quatre
mètres au maximum. Toutefois, cette
distance maximale peut varier en fonc-
tion des circonstances extérieures. Pour
vous assurer que le clavier fonctionne
correctement à
la position souhaitée,
vous devez le tester
avant d’entamer
le montage
.
Maintenez le clavier à
l’emplacement de
montage souhaité (Fig.
105).
Saisissez votre code administrateur
ou code utilisateur et véri
fi
ez que le
cylindre est activé (Fig.
106).
Remarque
:
le code administrateur,
si vous ne l’avez pas déjà modi
fi
é, se
trouve sur l’autocollant inclus dans
l’emballage du cylindre secuENTRY
(Fig.
107). Vous pouvez trouver com-
ment créer un code utilisateur dans
les instructions principales de votre
cylindre secuENTRY.
Si le cylindre peut être activé, l’intensité
du signal est su
ffi
sante et vous pouvez
monter le clavier à
l’emplacement
souhaité. Sinon, réessayez avec une
distance inférieure entre le cylindre et
le clavier.
Fig.
107
:
Autocollant avec le
code QR pour cylindres
secuENTRY.
Code administrateur
attribué en usine
PD[LbP
!
Fig. 105
Fig. 106
Montage de l’ENTRY
7711
Keypad
PIN – Vissé
1
3
4
5
2
Percez trois trous selon les dimen-
sions indiquées sur l’illustration.
Utilisez une mèche d’un diamètre de
6
mm (Fig.
108).
Insérez les chevilles incluses dans les
trous et vissez-y les vis également
incluses (Fig.
109).
Retirez la vis de la face inférieure du
clavier à
l’aide du tournevis Tx8 fourni
et retirez le compartiment des batteries
vers le bas (Fig.
110).
Placez le clavier sur les têtes de vis
comme illustré (Fig.
111).
Replacez le compartiment à
batteries
dans le boîtier et vissez-le fermement
(Fig.
112).
bPP
bPP
bPP
Fig. 108
Fig. 109
Fig. 110
Fig. 111
Fig. 112