4
I Englsih
secuENTRY HOME 5000 CYL
Connecting ENTRY 7711 Keypad PIN and secuENTRY profile cylinder
Fig. 15
Fig. 24
Fig. 21
Fig. 17
Fig. 18
Fig. 16
Fig. 25
Fig. 22
Fig. 23
Once you have successfully registered
the
ENTRY 7711 Keypad PIN
in the
KeyApp, you can start connecting
the keypad and a previously installed
secuENTRY cylinder. Open the main
menu (Fig. 15).
Tap on the menu item
"secuENTRY setup"
(Fig. 16).
Press and hold the CLOSE button for
five seconds (II) (Fig. 23) until the signal
LEDs on the keypad illuminate one
after the other in a clockwise direction
(Fig. 25).
The keypad is now in programming
mode. The next steps are carried out on
the smartphone again.
Attention:
For the following step, the smartphone,
keypad and cylinder must be in direct
proximity to each other.
Tap on the button
"LED BLINK FAST, CONTINUE"
(Fig. 26).
If the link is successful, you will receive
a completion message, which you
confirm with
"OK"
(Fig. 27).
The keypad and cylinder are now
successfully connected.
Activate the keypad with the ON button
(Fig. 23).
Enter the safety code (SCD) supplied.
The safety code can be found on the
sticker (I) enclosed with the keypad
(Fig. 24).
This takes you to the menu illustrated
(Fig. 21). Briefly lay the smartphone
aside and set the keypad to program-
ming mode using the following steps.
First, remove the battery protection
strip from the keypad (Fig. 22).
In the following menu, tap on
"Device
Setup"
(Fig. 17). From here you can add
and setup secuENTRY units to the app.
Use the selection menu displayed and
tap on
"secuENTRY KeyPad"
to display
setup secuENTRY keypads (Fig. 18).
Tap the keypad entry that is to be
assigned to a cylinder (I) (Fig. 19).
Then tap on
"Allocate a Lock"
(II)
(Fig. 19).
A list of available secuENTRY cylinders
appears (Fig. 20).
Select the required cylinder (I) and
confirm with
"CONTINUE"
(II) (Fig. 20).
1
2
8
12
11
9
10
4
3
5
6
7
Fig. 19
Fig. 20
I
I
II
II
!
5 seconds
QR
I
II
Fig. 26
Fig. 27
14
13
