TSE BUSINESS 5000
English
|
11
Mistakes and changes reserved.
5
Shift the inner knob over the shaft until attaining the required dimension.
Please make sure that the clearance between the knob and the door
mounting is at least 1 mm. Then fix the knob using the hex key.
6
Before you fix the outer knob, please consider whether you wish to use
the attached cover panel for the profile cylinder section. If so, remove the
protective films and fix the cover panel onto the fitting.
7
Shift the outer knob into the required position on the shaft and fix it with
a clearance of at least 1 mm from the mounting using the hex key.
8
Remove the battery protective strip from the inner knob.
9
The function test should be performed with an open door.
Replacement of batteries – knob (inner side)
1
Using the attached hex key, loose the top locking screw on the knob
cover. It can be turned out only up to the opening of the cover and will
not fall out.
2
Lift the cover up.
3
Replace the batteries. Make sure the batteries are inserted with a correct
polarity, indicated at the marked point on the housing.
4
Replace the cover.
Emergency key function (outer side)
Using the emergency key, you can provide access in case of failure of the
system.
1
Swing the emergency key open and then insert it into the indicted
slot in the cover panel.
2
Turn the key 90° clockwise. If required, move the outer knob slightly to
the right and left in order to release the mechanism.
3
Turn the outer knob. The lock opens when fully turned, at the latest.
Turn the key to its initial position and take it out. To close the emergency
lock, the knob shall be turned twice fully in both directions.
Attention:
The lock may neither be greased nor oiled!
