B-Smart-Lock Corona
|
March 2017
01- AN/DSW English
ǀ
4
Configuration
1.
Open the battery compartment door. You will need a
Torx 8 screwdriver.
2.
Remove the right battery (left hand latch)
3.
Press the white button on the board and hold it down
until a ticking sounds. (Do not press the button with
metallic objects.)
4.
Now hold the master card in front of the knob within the
next 5 seconds and while it is still ticking. Two ascen-
ding sounds confirm the successful authorisation of the
master card. Assignment of the card can take up to two
seconds.
5.
Insert the batteries and close the battery compartment
cover.
maste
r card
1.
2.
3.
4.
+
Confirmation by two ascending tones
Torx 8
Note: Up to three master cards can be assigned.
Assign master card
Transponder assignment
Applies to private mode.
1.
Place the lock in the open status, so that the knob can
be turned.
2.
Hold the master card in front of the knob until the ti-
cking sounds.
3.
Keep the transponder which is to be assigned in front of
the knob while it is still ticking. Two ascending tones
confirm the successful assignment of the transponder.
Note: The ticking is extended by five seconds after each
transponder, so you can assign more transponders.
1.
2.
+
maste
r card
transpo
nder
3.
Hold the master card in front of the knob
until the ticking sounds.
Hold the transponder in front of the knob
while it is ticking. Confirmation by two
ascending tones.
Unassigning transponders (in private mode)
Use the same procedure as when assigning transponders. If
you no longer have the transponder, you can unassign them
using the
reset all transponder
feature.
Note: All transponders will be deleted during the reset.
