sPinLock 200 | 03-2020
Rev. 02 | English | 4
Assembly Instructions
Prepare the appropriate mounting hole (16 x 19 mm) on
your furniture. Make sure that the bolt included in the sco-
pe of delivery reaches behind the strike plate (not included
in the scope of delivery) or behind an existing rebate of
your piece of furniture (min. 4 mm) when mounted and
when the door is closed. Only then drill the mounting hole
required for installation.
Tip: If you produce furniture in a larger quantity using CNC
milling, the use of 3D step data is recommended.
Place the lock on the door and push the shank through the
mounting hole. Make sure that you place the lock straight.
Place the nut on the thread and tighten the lock sufficiently.
Note: For wooden furniture, the mounting hole can be dril-
led circularly. In this case the use of an anti-twist protection
is recommended. During assembly, the anti-twist protection
is placed on the thread and screwed tight with the nut.
To simplify the installation of the bolt, bring the lock into
the open position. Then place the bolt on the cross bar of
the shank so that it is in the open position and hold it in
place.
Fasten the latch with the screw. Check if the latch can close
as desired. Ideally, the lock can be closed easily without the
bolt being under tension.
1
2
3
4
5
