60
Operation
Type 8792, 8793 REV.2
13.4.1 Setting date and time:
Activate the input screen as follows:
→
On the process level select the display for
CLOCK
using the arrow keys .
→
Press
INPUT
to open the input screen for the setting.
→
Set date and time as described in the following table.
You have activated the input screen.
Set the date and time as follows:
→
Select
<-
.
Switch to the next time unit (from right to left).
When the last time unit for the date has been reached, the display switches to the time units for the time.
If the last unit is at top left (hours), the display switches back to the first unit at bottom right (year).
→
Select
+
.
Increase value.
When the largest possible value has been reached, 0 is displayed again.
→
Select
ESC
. Return without change.
→
Select
OK
. Accept the set value.
→
/ Select
EXTRAS
.
→
Select
ENTER
. The submenus of
EXTRAS
are displayed.
→
/ Switching the display.
You have set date and time.
13.5
Operating states
Type 8792/8793 has 2 operating states: AUTOMATIC and MANUAL.
When the operating voltage is switched on, the device is in the AUTOMATIC operating state.
MENU CMD
POS MANU
POS
0.0
AUTOMATIC
In the AUTOMATIC operating state normal
controlled operation is implemented.
(The symbol for AUTOMATIC
is shown on the display.
A bar runs along the upper edge of the display).
english
Summary of Contents for 8792
Page 196: ...www burkert com ...
