65
Start-up
Type 8792, 8793 REV.2
14.2
Basic setting of the device
The following settings must be made for the basic setting of Type 8792/8793:
1.
INPUT
Selection of the input signal (see chapter “14.3”).
2.
X.TUNE
Automatic self-parameterization of the position controller (see chapter “14.5”)
14.3
INPUT
- Setting the input signal
This setting is used to select the input signal for the set-point value.
Set the input signal as follows:
→
Press
MENU
for 3 s. Switching from process level
setting level.
→
/ Select
INPUT
.
→
Select
ENTER
. The possible input signals for
INPUT
are displayed.
→
/ Select input signal
(4...20 mA, 0...20 mA, ...)
Select.
→
Select
SELECT
. The selected input signal is now marked by a filled circle .
→
Select
EXIT
.
Return to the main menu (MAIN).
→
Select
EXIT
. Switching from setting level
process level.
You have set the input signal.
english
Summary of Contents for 8792
Page 196: ...www burkert com ...