Image 7:
1U vent above
B16
chassis allows for proper ventilation
1.5 Attach Ribbon Cables To Faceplate
Note: Newer cards only have ribbon cable. Older cards have ribbon cable
and
power cable
(See
Image 6
).
(If applicable) The
red
wire should be closest to the
orange
power connector. Make sure the
orange
2 pin connector is attached properly.
1.6 Attach Lid With All Screws
1.7 Install Vent ABOVE B16 Chassis
The
MOTHERSHIP
must
run with proper ventilation!
Failure to properly vent the
MOTHERSHIP
chassis above may cause failure, and will void the
warranty.
Image 6:
Connect ribbon cable and 2 pin connector
(
BAD4
/
BDA8
) or ribbon cable (
BAD8
)
3
CHAPTER 1