connecting the LouDspeAkers
16
5.6.2 Horizontal bi-amping
When using dual-channel (stereo) amplifiers, in a horizontal bi-amping arrangement,
one amplifier is connected to the woofer units and one amplifier to the mid-range/
tweeter units on both speakers. The advantage of this variant is that the amplifier for
the (acoustically important) mid-range/tweeter unit no longer has to furnish the high
power required by the woofer unit. The disadvantage is that this variant requires the
same cable lengths as those for the classic connection option and for bi-wiring.
3.
R
L
R
L
R
L
+
–
+
–
+
–
+
–
1.
1.
2.
4.
5.
6.
7.
3.
Connecting the speakers:
1.
Center the two stereo amplifiers between the loudspeakers.
2.
Connect the preamplifier to the stereo amplifiers as shown in the diagram. You will
need two optional Burmester bi-amp adapters or adapter cables. Please contact
your specialist dealer for assistance.
3.
On the speaker connector panel, remove the bi-wiring jumpers between the woofer
terminals (LOW) and the tweeter/mid-range terminals (HI/MID) located above them.
Right speaker:
4.
Connect the woofer unit to the right output of the right amplifier.
5.
Connect the mid-range/tweeter unit to the right output of the left amplifier.
Left speaker:
6.
Connect the woofer unit to the left output of the right amplifier.
7.
Connect the mid-range/tweeter unit to the left output of the left amplifier.
8.
After connecting the speakers, continue by reading „Operating the Loudspeakers“
on page 18.
Summary of Contents for AMBIENCE 31
Page 1: ...A M B I E N C E 3 1 Operating Manual...
Page 2: ......
