32
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
heating installation pump regardless of
the temperature of domestic hot water. In
"Summer Mode"
the room thermostat is
disabled.
Lights for operating:
-
Pump heating system
-
Pump Domestic hot water
.
10.2. User menu
10.2.1. Initial (start-up screen) „Standby“
The burner is in
standby mode.
The display shows:
Temperature in the
boiler (23 degrees),
time, and by pressing the Enter button
you can browse the quick menu (bottom
left) where the following read-only data
is displayed:
Maximum set temperature
t=85
o
C
,
temperature of domestic hot
water
where such heating circuit is
connected);
Light intensity in the burner
;
Burner status
(detected errors, if any);
Date.
Error message. If there
is an emergency in the
operation of the facility for any reason will
be displayed as an error.
Мaximum set boiler
temperature.
Current date.
Parameter
t
DHW
indicates temperature
of domestic hot water inside the water
heater.
Parameter t
СН
indicates
the
value
of
instantaneous temperature at upper and
bottom part of the buffer tank.
This screen is active only when has been
selected the menu option for boiler
control according to buffer temperature.
Parameter
t
E
indicates
exhaust
gases
temperature.
Set
maximum
temperature of the
boiler
through
navigation arrows.
When desired temperature is selected
press
Enter
. Press button
F
and hold for 3
seconds to set the follow parameters:
Possibility for forced
turn on of ash and soot
transport screw. Time
setting
of
screw
operation. To set start and operating time
use buttons
“Navigation arrow Up”
and
“Navigation arrow Down”.
After entering
the correct value press button
“Enter”
.
Use this menu to adjust
switch-on temperature
of
central
heating
pump.
From this menu you can
preset buffer tank
circulation
pump
switch-on and switch-
off temperatures provided such heating
installation scheme (with buffer tank
included) is selected, whereas the two
sensors reading these temperatures are
mounted in the upper, respectively lower
part of the buffer tank (cf. boiler
connection schemes).
From this menu you can
adjust the maximum
temperature in the
domestic hot water
storage tank, whereas by navigating from
the arrow keys up and down and using the
E
nter
button you can change the
parameters. You can adjust the maximum
domestic hot water temperature inside
