19
Repair and Maintenance
WARNING:
To avoid a pinch or injury keep
fingers away from moving
sprockets and chain.
WARNING:
To prevent shock, please
follow the instructions
accordingly and do not skip or
combine any steps.
Note:
Li-ion battery and
Lead acid battery may be
interchanged in the TT250
models but you must use
the correct charger with the
battery used.
Replacing the Fuse Lead-Acid Battery
(ONLY)
1. Remove two M5 screws removing the battery
cover from right side. Remove battery strap and
slide battery set out.
2. Locate the fuse box attached to the batteries.
Open the fuse cover to expose the fuse.
3. Remove the fuse and replace with a new one of
equal amperage. A small spark may occur when
install the new fuse. Requires 30-amp fuse. Close
the fuse cover and reattach the battery cover.
Battery Replacement
Lead-Acid
batteries (2-12v 7ah) should be replaced in
sets only and with original Burromax Batteries!
Li-ion battery
(24V and 36V)
. Non-replaceable
internal breaker
only use the Burromax Li-ion
battery and Li-ion Battery charger together.
Retailers do not have the same quality as our OEM
batteries. Performance may be seriously affected
1. With battery cover removed disconnect hold
down strap.
2. Slide battery set out of mounting tray.
3. Disconnect battery connection. Re-install new
battery set and reconnect.
4. When reconnecting new battery set you may get
a small spark.
5. Tuck in wires and reassemble.
Lithium-ion Battery
Lead-Acid Battery
Fuse