Factory Reset
It is possible to factory reset the lock and reset the master code back to
the factory default code ‘111111’ and remove the secondary code.
• Open the safe with a valid 6-10 digit code, then open the safe door
• Reach around the inside of the safe door and locate the
[PROGRAMMING] key - Do not press this key yet
• Press the [ON] key and the [PROGRAMMING] key together and hold
for 5 seconds
Setting / changing the user codes
When setting up and changing your user codes you program the master
and the secondary code together. You program the master code first,
followed by the secondary code. Therefore if you want to set up/make
changes to the secondary code you have to go through your master code
setup first. If you do not wish to set up a secondary code, after you have
programmed the master code wait a few seconds and the keypad will
signal with multiple tones to confirm that the secondary code is not being
added.
• Open the safe with a valid 6-10 digit code, then open the safe door
• With the safe door open press the [ON] key
• Now reach around the inside of the safe door to press the
[PROGRAMMING] key
• The CODE LED will light up in green
• Within 10 seconds input your new 6-10 digit code for your master code
• Press the [ENTER] key
• Re-enter the new master code followed by the [ENTER] key
(If you do not wish to program the secondary code stop here)
• Press the [PROGRAMMING] key
• Enter a 6-10 digit code for the secondary code followed by the
[ENTER] key
• Re-enter the new secondary code followed by the [ENTER] key
• The keypad will sound multiple tones to confirm that both codes have
been set
