32
33
IT
ES
NL
FR
EN
DE
8. Operation
To be ready for operation, the LEVAL must be supplied with electric power. If the LEVAL is connected
in parallel together with the lighting system (see „6.1. Electrical connection of the LEVAL and the
headlight to the e-bike’s light output“), this works by switching on the lighting system on the bicycle
display.
If the LEVAL is supplied by a separate power source (see „6.2. Electrical connection of the LEVAL to
a separate power source“), this power source must be activated.
While the LEVAL switch activates (“ON“) or deactivates (“OFF“) the LEVAL functions, it does not turn
it off completely. LEVAL remains in the standby mode.
!
Even in the standby mode, the sensors are still active and consume a small amount of power to
keep the LEVAL active in the centre position. When restarted, the LEVAL is immediately ready for use.
To turn off the LEVAL completely, you must disconnect the power supply (either switch off the light-
ing system or the power source, depending on the connection). If the LEVAL is disconnected from the
power supply, it maintains the current position. Only when the switch
3
is set to „OFF“
the LEVAL mechanism moves it to the centre for its final position.
!
Setting and fixing the LEVAL in the centre position is possible at any time, mechanically without
power, by setting the switch
3
to „OFF“.
When not in use, switch the LEVAL to „OFF“ (= standby mode) using the switch
3
to save power and
prevent unnecessary wear and tear. The LEVAL then aligns itself centrally and is fixed like a standard
holder without further functions. This function still allows safe cycling even when the LEVAL is not
switched on.
WARNING
While cycling, operate the LEVAL exclusively via the bicycle display or the control of
the lighting system, but never on the LEVAL itself or via other components (power bank, etc.). Always
interrupt your ride to prevent accidents and falls.
9. Additional information
Disposal:
Electronic components must not be handled as household waste but are to be disposed of
as hazardous waste.
10. Liability
In addition to the above-mentioned exclusions of warranty, we do not assume liability for any and
all other damage caused by improper handling (e.g. dropping the system, inadequate safety of
assembly and its consequences, submersion in water or other liquids etc.). Neither do we assume
any liability if silver screws are loosened. Ball bearings and moving parts are subject to a reduced
warranty of six months.
Have fun and enjoy safe cycling with your LEVAL!
Technical modifications reserved.
Busch + Müller KG • 58540 Meinerzhagen, Germany • Tel. +49 2354 915-6000 • info@bumm.de •
www.bumm.de
Summary of Contents for LEVAL 365
Page 50: ...98 99 ...
