11. BUCKET ATTACHMENT
QUICK DRAW BUCKET
IMPORTANT: Refer to pages 29 & 30 for instruc-
tions concerning Installing Attachment to Quick
Draw Latch Attach.
IMPORTANT: Refer to page 31 for instructions
concerning Removing Attachment from Quick
Draw Latch Attach.
Quick draw buckets are available as follows.
72 inch, 84 inch, and 96 inch wide for Bush Hog
3860 Loaders.
These buckets utilize a replaceable weld-on cutting
edge, and are pre-punched for tines.
Heavy duty/high capacity quick draw buckets are
available as follows.
72 inch, 84 inch, 96 inch, and 102 inch wide for Bush
Hog 3860 Loaders.
These buckets utilize a replaceable bolt-on cutting
edge.
These buckets are equipped with a clevis mounting
point for lifting. Refer to Figure 1.
CAUTION
NEVER LIFT ANY LOAD FROM ANY POINT
OF THE LOADER WITH A CHAIN, ROPE, OR
CABLE UNLESS LOADER IS EQUIPPED
WITH A BUSH HOG FACTORY APPROVED
ATTACHMENT WHICH WAS DESIGNED
AND BUILT FOR THIS TYPE OF LIFTING.
ALWAYS FOLLOW LIFTING INSTRUCTIONS
INCLUDED WITH THIS ATTACHMENT.
NEVER TOW FROM ANY POINT OF THE
LOADER WITH A CHAIN, ROPE, OR
CABLE. DOING SO COULD CAUSE A ROLL
OVER OR SERIOUS DAMAGE TO THE
LOADER.
MAXIMUM LOAD LIMIT ON BUSH HOG
CLEVIS AND CLEVIS MOUNTING POINT IS
6500 POUNDS. FAILURE TO FOLLOW
THESE INSTRUCTIONS COULD CAUSE
DAMAGE TO LOADER AND/OR INJURY TO
OPERATOR.
Figure 1
(1) Bucket, heavy duty, high capacity.
(2) Clevis mounting point.
(3) Clevis (use only Factory approved clevis).
(4) Clevis pin.
(5) Cotter Pin.
SINGLE TINE KIT
Single tine kits are available for mounting on pre-
punched buckets as follows. Each single tine kit
includes one tine and attaching hardware.
72 inch quick draw buckets are punched for eight (8)
single tine kits.
84 inch quick draw buckets are punched for ten (10)
single tine kits.
96 inch quick draw buckets are punched for ten (10)
single tine kits.
32
