Bush Palace
Eagle
Setup Guide
© 2017 Bush Palace Camper Hire
10
IF YOU ARE FREE CAMPING….
I.e. there is no mains water/240v power available. In this case you are reliant on the 2 x 82l water
tanks, the 2 x 100a/h batteries, and the 2 x 9Kg gas cylinders.
•
Make sure water tanks are full. They are filled via the fillers inside the small black door at the
rear of the right side of the camper.
•
Switch on the water pump using the switch on the control panel (located in the club lounge
area). The control panel also shows how much water is remaining and battery status.
•
Turn on the gas bottles in the front boot, making sure to push down on the gas fuse.
•
Set the fridge to gas (gas symbol) and ignite by holding down button a pressing igniter until
lit. The red needle on the small green and white gauge will move to the green area once the
fridge is lit.
Hot Water (Gas)
•
Outside camper, open the hot water cover and make sure switch is set to OFF
•
Inside camper, ensure battery switch and water pump are on
•
flick tap to hot and ensure water is flowing
•
Turn on the white ‘Water Heater’ switch inside the camper. A red light will ignite and remain lit
until the hot water burner has ignited. Turn switch off when not in use.
•
Do not light the hot water with no water in the tanks.
•
HWS takes ~20 minutes to heat water
Water pump switch (r/h
button on control panel)
Gas hot water switch &
battery switch
Fridge gas setting
Lighting the fridge
Fridge indicator when
gas is lit