Page 6
User instructions
Operating instructions (cont)
5:
When sucking up liquids, ensure the Vacuum is
positioned at least
40
-
90
degrees.
NOTE:
Never allow liquids to come into contact
with the motor.
MAX.
MAX.
M
AX
.
40 Degrees
5:
When finished empty the
DUST CONTAINER
of all
liquid and dry before storage, storing wet or damp can
affect future suction and also run the risk of electrical
shock if docked on the charging bracket.
NOTE:
This Vacuum is intended for NORMAL
household usage only.
Cleaning & maintenance
REMOVING THE DUST CONTAINER
1:
Press the
DUST CONTAINER RELEASE SWITCH
on
the top of the handle, and slide the
DUST CONTAINER
away from the motor section.
MAX.
MAX.
M
AX
.
40 Degrees
2:
To re-fit the
DUST CONTAINER
, slide the
CONTAINER
back onto the motor section until it locates the
bottom pip first and then locate the hole in the top of
the
DUST CONTAINER
, it will then click into place.
Cleaning & maintenance (cont)
CLEANING THE DUST CONTAINER & FILTER
1:
Remove the
DUST CONTAINER (see step 1 of
removing the dust container)
,
2:
Remove the
FILTER
by sliding the entire plastic
section out of the largest end of the
CONTAINER.
MAX.
3:
Clean the
DUST FILTER
section and if required the
inside of the
DUST CONTAINER.
4:
Re-fit the
FILTER
inside the
CONTAINER (Ensure
the filter is pushed fully up to the stops inside the
container)
and follow step
2
of
‘removing the dust
container’
to re-fit the
DUST CONTAINER.
REPLACING THE FILTER
After time the filter will become clogged with particles
and will require changing. Follow the below steps to
replace the dust filter.
1:
Follow steps
1
-
3
to remove & clean the
DUST FILTER.
2:
Take a small cross head screwdriver and unscrew the
2
screws in the Filter to remove the filter block.
3:
Insert the replacement filter block, replace the
screws and tighten again.
4:
Once secure push the
FILTER
back inside the
DUST
CONTAINER
until fitted snugly.
NOTE:
Replacement filters are available to
purchase. Please see details in the rear of this
manual.
