If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions.
14
Installation warnings
Before using your fridge freezer for the first time,
please pay attention to the following points:
•
The operating voltage for your fridge freezer
is 220-240 V at 50Hz.
•
The plug must be accessible after installation.
•
Your fridge freezer may have an odour when
it is operated for the first time. This is normal
and the odour will fade when your fridge
freezer starts to cool.
•
Before connecting your fridge freezer, ensure
that the information on the data plate (voltage
and connected load) matches that of the
mains electricity supply. If in doubt, consult a
qualified electrician.
•
Insert the plug into a socket with an efficient
ground connection. If the socket has no
ground contact or the plug does not match,
we recommend you consult a qualified
electrician for assistance.
•
The appliance must be connected with a
properly installed fused socket. The power
supply (AC) and voltage at the operating point
must match with the details on the name
plate of the appliance (the name plate is
located on the inside left of the appliance).
•
We do not accept responsibility for any
damages that occur due to ungrounded
usage.
•
Place your fridge freezer where it will not be
exposed to direct sunlight.
•
Your fridge freezer must never be used
outdoors or exposed to rain.
•
Your appliance must be at least 50 cm away
from stoves, gas ovens and heater cores, and
at least 5 cm away from electrical ovens.
•
If your fridge freezer is placed next to a deep
freezer, there must be at least 2 cm between
them to prevent humidity forming on the
outer surface.
•
Do not cover the body or top of fridge freezer
with lace. This will affect the performance of
your fridge freezer.
•
Clearance of at least 150 mm is required
at the top of your appliance. Do not place
anything on top of your appliance.
•
Do not place heavy items on the appliance.
•
Clean the appliance thoroughly before use
(see Cleaning and Maintenance).
•
Before using your fridge freezer, wipe all parts
with a solution of warm water and a teaspoon
of sodium bicarbonate. Then, rinse with clean
water and dry. Return all parts to the fridge
freezer after cleaning.
•
Use the adjustable front legs to make sure
your appliance is level and stable. You can
adjust the legs by turning them in either
direction. This must be done before placing
food in the appliance.
•
Install the two plastic distance guides (the
parts on the black vanes
-condenser- at the rear) by
turning it 90° (as shown in the
figure) to prevent the condenser
from touching the wall.
•
The distance between the
appliance and back wall must be a maximum
of 75 mm.
During Usage
•
Do not connect your fridge freezer to the
mains electricity supply using an extension
lead.
•
Do not use damaged, torn or old plugs.
•
Do not pull, bend or damage the cord.
•
Do not use plug adapter.
•
This appliance is designed for use by adults.
Do not allow children to play with the
appliance or hang off the door.
•
Never touch the power cord/plug with wet
hands. This may cause a short circuit or
electric shock.
•
Do not place glass bottles or cans in the ice-
making compartment as they will burst when
the contents freeze.
Installing your Combi Fridge - Freezer
Installing your Combi Fridge - Freezer
Bringing it all together
Summary of Contents for 54152B
