Bush 54152B, Instruction Manual

25

or online at 

www.bush-support.com

 If you still require further assistance, call one of our experts on 

0345 257 7271

.

Care and maintenance

Looking after your appliance

Care and maintenance

Cleaning and maintenance

General

Disconnect the unit from the power supply 
before cleaning.
Do not wash your appliance by pouring water 
on it.
Do not use abrasive products, detergents or 
soaps for cleaning the appliance. After 

washing, rinse with clean water and dry carefully. 
When you have finished cleaning, reconnect the 
plug to the mains supply with dry hands.

• 

Make sure that no water enters the lamp 
housing and other electrical components.

• 

The appliance should be cleaned regularly 
using a solution of bicarbonate of soda and 
lukewarm water.

• 

Clean the accessories separately by hand with 
soap and water. Do not wash accessories in a 
dish washer.

• 

Clean the condenser with a brush at least 
twice a year. This will help you to save on 
energy costs and increase productivity.

The power supply must be disconnected 
during cleaning.

Defrosting

De

frosting the Refrigerator Compartment

• 

Defrosting occurs automatically in the 
refrigerator compartment during operation. 
The water is collected by the evaporation tray 
and evaporates automatically.

• 

The evaporation tray and the water drain 
hole should be cleaned periodically with the 
defrost drain plug to prevent the water from 
collecting at the bottom of the refrigerator 
instead of flowing out.

• 

You can also clean the drain hole by pouring 
half a glass of water down it.

Freezer defrosting process

• 

Small amounts of frost will accumulate 
inside the freezer, depending on the length 
of time the door may be left open or the 
amount of moisture introduced. It is essential 
to ensure that no frost or ice is allowed to 
form in places where it will affect the close 
fitting of the door seal. This might allow 
air to penetrate the cabinet, encouraging 
continuous running of the compressor. 
Thin frost formation is quite soft and can be 
removed with a brush or plastic scraper. Do 
not use metal or sharp scrapers, mechanical 
devices or other means to accelerate the 
defrosting process. Remove all dislodged frost 
from the cabinet floor. It is not necessary to 
switch off the appliance for the removal of 
thin frost.